Register

A 1.5-kg specimen of a 90 wt% Pb-10 wt% Sn alloy (Animated Figure 9.8) is heated to 250°C; at this temperature it is entirely an α-phase solid solution. The alloy is to be melte…

A 1.5-kg specimen of a 90 wt% Pb-10 wt% Sn alloy (Animated Figure 9.8) is heated to 250°C; at this temperature it is entirely an α-phase solid solution. The alloy is to be melte…
asked 124k views
0 votes
A 1.5-kg specimen of a 90 wt% Pb-10 wt% Sn alloy (Animated Figure 9.8) is heated to 250°C; at this temperature it is entirely an α-phase solid solution. The alloy is to be melted to the extent that 50% of the specimen is liquid, the remainder being the α phase. This may be accomplished either by heating the alloy or changing its composition while holding the temperature constant.

asked
User Boushley
by
7.8k points

1 Answer

10 votes

Answer:

A. By hit and trial method 280 C

Step-by-step explanation:

ion know B sorry

answered
User Kirzilla
by
7.9k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to Qamnty — a place to ask, share, and grow together. Join our community and get real answers from real people.

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
Link Copied!