Register

Student A says that wires on a screw-type terminal connection should be installed as shown in Figure A - 5 . Student 8 says that wire nut connections are a type of soldere conne…

Student A says that wires on a screw-type terminal connection should be installed as shown in Figure A - 5 . Student 8 says that wire nut connections are a type of soldere conne…
asked 137k views
2 votes
Student A says that wires on a screw-type terminal connection should be installed as shown in Figure A - 5 . Student 8 says that wire nut connections are a type of soldere connection. Which of the following statements is correct?

asked
User ChechoroArtem
by
8.8k points

1 Answer

3 votes

Answer:

Student A

Step-by-step explanation:

There is no reason to solder a wire nut connection because the nut already makes a mechanical connection.

answered
User Gregor Koukkoullis
by
7.8k points
← Prev Question Next Question →

Related questions

User Rasel Khan
asked Aug 4, 2024 17.1k views
To lock a part onto a(n) blank a set screw is often used. A) Shaft B) Nut C) Bolt D) Gear
Rasel Khan asked Aug 4, 2024
by Rasel Khan
7.7k points
1 answer
0 votes
17.1k views
Ask a Question
Welcome to Qamnty — a place to ask, share, and grow together. Join our community and get real answers from real people.

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!