Register

When performing plasma-arc cutting near a battery, the operator should remove the battery to prevent

When performing plasma-arc cutting near a battery, the operator should remove the battery to prevent
asked 198k views
0 votes
When performing plasma-arc cutting near a battery, the operator should remove the battery to prevent

asked
User BigCheesy
by
8.2k points

1 Answer

6 votes

Answer: sparks and/or electrical currents

Step-by-step explanation:

answered
User Riaz Laskar
by
7.3k points
← Prev Question Next Question →

No related questions found

Ask a Question
Welcome to Qamnty — a place to ask, share, and grow together. Join our community and get real answers from real people.

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
Link Copied!