Register

The tailstock a. is used to mount the lathe center b. cannot be used for taper turning C. is removed when long work must be turned D. holds the inner end of the work being turne…

The tailstock a. is used to mount the lathe center b. cannot be used for taper turning C. is removed when long work must be turned D. holds the inner end of the work being turne…
asked 145k views
0 votes
The tailstock

a. is used to mount the lathe center
b. cannot be used for taper turning
C. is removed when long work must be turned
D. holds the inner end of the work being turned

asked
User Weisj
by
8.2k points

1 Answer

5 votes
the anwser is c or d
answered
User Pedrouan
by
7.9k points
← Prev Question Next Question →

Related questions

User Takeshin
asked Oct 8, 2021 145k views
The Tailstock setover for a 10 inch long peice needing a 0.18 inch taper per fot is _____ inches?
Takeshin asked Oct 8, 2021
by Takeshin
8.1k points
1 answer
3 votes
145k views
Ask a Question
Welcome to Qamnty — a place to ask, share, and grow together. Join our community and get real answers from real people.

Categories

Other Questions

An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!