Question

in this lab, you'll explore how various actions affect the status of the serial interface. the sfo router is connected to the lax router using the serial interfaces indicated in the network diagram. the serial interfaces have not been configured. in this lab, your task is to: use the show interfaces command on both routers and answer question 1. remove the shutdown from both interfaces and answer question 2. use the show controllers s0/1/0 command on sfo and answer question 3. set the clock rate to 9600 on sfo and answer question 4. view the running-config on sfo and answer question 5. set the clock rate to 9600 on lax. use the show interfaces command on both router and answer questions 6-7. use the show ip interface command on both router and answer question 8. change the encapsulation to ppp on sfo and answer question 9. change the encapsulation back to hdlc on sfo.

Answer 1

In this lab, you will be exploring how various actions affect the status of the serial interfaces between the SFO and LAX routers. The serial interfaces have not been configured, and your task is to perform several actions and answer questions based on the resulting status changes.

You will begin by using the "show interfaces" command on both routers and answering question 1. Next, you will remove the shutdown from both interfaces and answer question 2. Then, you will use the "show controllers s0/1/0" command on SFO and answer question 3.

After that, you will set the clock rate to 9600 on SFO and answer question 4, followed by viewing the running-config on SFO and answering question 5. Then, you will set the clock rate to 9600 on LAX and use the "show interfaces" command on both routers to answer questions 6 and 7.

You will also use the "show ip interface" command on both routers and answer question 8. Finally, you will change the encapsulation to PPP on SFO and answer question 9, and then change it back to HDLC.

In summary, this lab involves performing various actions on the serial interfaces between the SFO and LAX routers, and observing the resulting status changes. You will use different commands and configurations to perform these actions, and answer questions based on your observations. Your answer should be no more than 180 words.