Register

Select the best answer for the question. 4. A quick way to check the evaporator for leaks is to remove the A. blower motor resistor pack. B. compressor. O C. orifice tube system…

Select the best answer for the question. 4. A quick way to check the evaporator for leaks is to remove the A. blower motor resistor pack. B. compressor. O C. orifice tube system…
asked 52.3k views
0 votes
Select the best answer for the question.

4. A quick way to check the evaporator for leaks is to remove the
A. blower motor resistor pack.
B. compressor.
O C. orifice tube system.
OD. upper radiator hose

asked
User CyrilleGuimezanes
by
8.5k points

1 Answer

1 vote

Answer:c

Step-by-step explanation:

Because it will take out the fuel right away

answered
User Windel
by
8.1k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to Qamnty — a place to ask, share, and grow together. Join our community and get real answers from real people.

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
Link Copied!